Bahasa

Mata Wang


logo
deep-groove-ball-bearing

Deep Groove Ball Bearing

For DEEP GROOVE BALL BEARINGS, pressed cages are usually used. For big bearings, machined brass cages are used. Machined cages are also used for high speed applications. MAXIMUM TYPE BALL BEARINGS contain a larger number of balls than normal deep groove ball bearings because of filling slots in the inner and outer rings. Because of their filling slots, they are not suitable for applications with high axial loads. BL2 and BL3 types of bearings have boundary dimensions equal to those of single-row deep groove ball bearings of Series 62 and 63 respectively. Besides the open type, ZZ type shielded bearings are also available. When using these bearings, it is important for the filling slot in the outer ring to be outside of the loaded zone as much as possible. Their cages are pressed steel. MAGNETO BEARINGS is the bearing groove in the inner ring is a little shallower than that of deep groove ball bearings and one side of the outer ring is relieved. Consequently, the outer ring is separable, which makes it convenient for mounting. Pressed cages are standard, but for high speed applications, machined synthetic resin cages are used. PRECAUTIONS FOR USE OF DEEP GROOVE BALL BEARINGS, if the bearing load is too small during operation, slippage occurs between the balls and raceways, which may result in smearing. The higher the weight of balls and cage, the higher this tendency becomes, especially for large bearings. If very small bearing loads are expected, please contact NSK for selection of an appropriate bearing.